The section covers the use of the SS7itty configurator, which is based
on the architecture of the AIX smitty facility. It takes the requirements
of the SS7 Cluster and constructs the relevant configuration files.
Preparation The first stage is to collect the relevant information together as described in Planning.
Running SS7itty To run SS7itty, first log on to the selected machine as dtuser, and enter the command SS7itty.
Configure SS7 Server This submenu is used to further define which AIX Computers are to be SS7 Servers.
Configure SS7 Link sets This submenu defines the grouping of the Links that have the same Destination Point Code. Use the information collected in the Signaling links table from Appendix A to create Link Sets. In most cases there will be only one Link Set.
Configure SS7 Route Sets This submenu defines the routing to the switches via the Link Sets. Use the information collected in the Route Set table from appendix A.
Configure SS7 trunks to Blueworx Voice Response trunks This submenu defines the Voice Bearer interconnections between the network and the Blueworx Voice Response systems. Use the information collected in the Trunk table to create entries.
Generate SS7 Configuration Files When all the necessary information has been entered into SS7itty, you can generate the configuration. To perform this task, select the Generate SS7 Configuration Files option from the top level menu.
Pack Configuration For detailed about information on pack configuration refer to the Blueworx Voice Response for AIX: Configuring the System information.