Configure SS7 Route Sets

This submenu defines the routing to the switches via the Link Sets. Use the information collected in the Route Set table from appendix A.

The following screen appears when you select the Add operation:

                                Add an SS7 Route
Type or select values in entry fields.
Press Enter AFTER making all desired changes.
                                                        [Entry Fields]
* SS7 Route Set Name                                 [           ]
* Switch Destination Point Code[x-x-x or hex]        []
* SS7 LinkSet 1                                      []                      +
  SS7 LinkSet 2                                      []                      +
  SS7 LinkSet 3                                      []                      +
  SS7 LinkSet 4                                      []                      +
* SS7 Bearer Trunks associated with this Route Set   []

Complete one of these screens for each Route Set in the Route Set table, as follows:

Route Set Name. The name given to this Route Set. SS7itty creates a unique name for this, which you can override. Typically, this would be the name of the switch. Note that when you create subsequent Route Sets, you must reenter the submenu to ensure that you assign a unique Route Set Name.
Switch Destination Point Code. Enter the value of the DPC from the table.
LinkSets. To select a predefined Link Set, use the list that is generated by pressing F4.
Bearer Trunks. This is a list of trunks that are being supplied by the Network under this DPC.

On completion, select the Show Summary option, and review the information that is displayed.