SDI received invalid request
A request has been received by the SDI process to perform an action, usually on a channel or trunk. This request was not valid, for one of the following reasons: - The request is not a valid type - The pack number or channel number is out of range - The pack is not in the correct state for the action to occur - The channel is not in the correct state for the action to occur
Check that all prerequisite actions are complete. For example, a pack cannot be placed in service until the pack has been made available, nor can any channel operations be performed until the pack is in service. Retry the operation when the prerequisite actions are complete. The relevant requests and states are shown below the message. If you can`t resolve the problem, reproduce it while running a system trace as documented in the Problem Determination information, ("trace -a -1" to start; "trcstop -1" to stop) and contact Blueworx Support.
White
Log, System Monitor