Stage 10

At this stage the following have been tested and proved to be working:

All D7 packages are installed and functioning correctly
All SS7 links are activated and working
All custom servers relating to D7 Enablement are installed and working

The circuit is now brought into service and verified. Perform the following on all Blueworx Voice Response clients:

Logon to the system as dtuser
Enter SS7_MAINT

Select the option M from the top level menu, and then M again. The following screen is displayed:

SS7 Circuit Status on b80e []
    │0   2   4   6   8  10  12  14  16  18  20  22
────┼───────────────────────────────────────────────
  17│
  18│B B B B B B B B B B B B B B B B B B B B B B B B
  19│B B B B B B B B B B B B B B B B B B B B B B B B
  20│B B B B B B B B B B B B B B B B B B B B B B B B
  21│B B B B B B B B B B B B B B B B B B B B B B B B
  22│B B B B B B B B B B B B B B B B B B B B B B B B
  23│B B B B B B B B B B B B B B B B B B B B B B B B
  24│B B B B B B B B B B B B B B B B B B B B B B B B
  25│B B B B B B B B B B B B B B B B B B B B B B B B
  26│B B B B B B B B B B B B B B B B B B B B B B B B
  27│B B B B B B B B B B B B B B B B B B B B B B B B
  28│B B B B B B B B B B B B B B B B B B B B B B B B
  29│B B B B B B B B B B B B B B B B B B B B B B B B
  30│B B B B B B B B B B B B B B B B B B B B B B B B
  31│B B B B B B B B B B B B B B B B B B B B B B B B
  32│B B B B B B B B B B B B B B B B B B B B B B B B
────┴───────────────────────────────────────────────
Selected Circuit ... 384
Call state             = IDLE
Near End Service state = Ubk
Far End Service state  = Ubk
Press Q to quit

Now bring the Blueworx Voice Response circuit into service, either from the System Monitor screen, or by using the wvrtrunk command from the system prompt.

The example above shows the first trunk is in service (not blocked by either end), while the remainder are blocked locally, as their trunks have not been brought into service. After completing the steps above, wait for a short period while the changes resulting from the last step take effect. Then select from the following:

Status	Action
No Bs (Block) are present on the display	Go to Stage 11: Inbound Traffic
Bs are present and the lower part of the screen indicates that there are near-end blocks.	Verify that all trunks have been brought into service.
Bs are present and the lower part of the screen indicates that there are far-end blocks .	Verify with the network operator and have the circuit brought into service.
Characters I or W are present.	Go to stage 10a.

Stage 10a: Possible message synchronization problem

. Try the following actions:

Using the Custom Server Manager GUI, stop and restart the SS7_D7 custom server. Then repeat stage 10.
Verify with the network operator and have the circuit brought into service.