Purpose
Registers,
removes or queries the owner of a DTTA.
Syntax
For DTTA use either:
dt_setowner -x -s adapter_number -t T1 | E1
or
dt_setowner -x -u adapter_number | -q adapter_number
For DTNA use:
dt_setowner -n -s adapter_number -t T1 | E1
Description
Use
the dt_setowner command to register Blueworx Voice Response as the
owner of a DTTA.
Other applications can use a DTTA, so if
you do not register Blueworx Voice Response as the
owner, Blueworx Voice Response cannot
use that DTTA.
- Before you use the dt_setowner command,
you must determine the identification number of every DTTA you want
to use. To do this, see Setting ownership of the DTTAs.
- Before you can run the dt_setowner command,
you must log in as root.
- You must run the dt_setowner command
before you start Blueworx Voice Response for the
first time.
- You must run the dt_setowner command
for every DTTA you
want to use.
Flags
- n
- Specifies the DTNA adapter
type.
- q
- Displays the name of the application that has registered
ownership of the DTTA.
- s
- Registers Blueworx Voice Response as the
owner of the DTTA.
- t
- Specifies whether the adapter is to be used for E1 or T1 telephony
(DTTA only)
- u
- Unregisters Blueworx Voice Response as the
owner of the DTTA.
- x
- Specifies the DTTA adapter
type.
- adapter_number
- The identification number of the adapter. For a DTTA it is
the rpqio number. For more information, see Setting ownership of the DTTAs. For a DTNA it is
the vnaio number. For more information, refer to
the Blueworx Voice Response for AIX: Voice over IP using Session
Initiation Protocol information.
Exit status
- 0
- Successful completion.
- >0
- An error occurred. Messages show the reason for the error.