Dial Tone Detection

Parameter group

Channel Group

Access level

Admin

Possible values

No (dial pause)
Yes (dial tone)

Defaults

No (dial pause)

Explanation

Specifies whether Blueworx Voice Response is to expect dial tone from the switch. If this value is set to No (dial pause), Blueworx Voice Response does not expect dial tone from the switch. Blueworx Voice Response takes action, for example, by sending outgoing address signals after the time specified for the Dial Pause parameter in the Signaling Type parameter group.

If this value is set to Yes (dial tone), Blueworx Voice Response does not take action until a valid dial tone is received from the switch. Dial tone, as defined by the correct call progress tone parameters, must be present for the amount of time specified by the Dial Tone Qualify Time parameter in the Signaling Type parameter group.

Note that dial tone detection is enabled for loop start channels, whether or not this parameter is set to No (dial pause).