dt_setowner command

Purpose

Registers, removes or queries the owner of a DTTA.

Syntax

For DTTA use either:

dt_setowner -x -s adapter_number -t T1 | E1

or

dt_setowner -x -u adapter_number | -q adapter_number

For DTNA use:

dt_setowner -n -s adapter_number -t T1 | E1

Description

Use the dt_setowner command to register Blueworx Voice Response as the owner of a DTTA. Other applications can use a DTTA, so if you do not register Blueworx Voice Response as the owner, Blueworx Voice Response cannot use that DTTA.

• Before you use the dt_setowner command, you must determine the identification number of every DTTA you want to use. To do this, see Setting ownership of the DTTAs.
• Before you can run the dt_setowner command, you must log in as root.
• You must run the dt_setowner command before you start Blueworx Voice Response for the first time.
• You must run the dt_setowner command for every DTTA you want to use.

Flags

n

Specifies the DTNA adapter type.

q

Displays the name of the application that has registered ownership of the DTTA.

s

Registers Blueworx Voice Response as the owner of the DTTA.

t

Specifies whether the adapter is to be used for E1 or T1 telephony (DTTA only)

u

Unregisters Blueworx Voice Response as the owner of the DTTA.

x

Specifies the DTTA adapter type.

adapter_number

The identification number of the adapter. For a DTTA it is the rpqio number. For more information, see Setting ownership of the DTTAs. For a DTNA it is the vnaio number. For more information, refer to the Blueworx Voice Response for AIX: Voice over IP using Session Initiation Protocol information.

Exit status

0

Successful completion.

>0

An error occurred. Messages show the reason for the error.